Rotek garbage chutes provide ease of use with their special diameter designs and hooper designs realized in accordance with the fields of use. The harmful matters contained in the garbage are eliminated by spraying chemicals.This way, they prevent bad odors and flies and have an important role in environmental health; in addition, they put an end to visual pollution, thanks to the closed system. Fresh air is circulated continuously in order to prevent harmful gases and bad odors from leaking into the rooms from the hoopers with the ventilation fans used in Rotek garbage chutes. Full safety is achieved with the warning lights on the hoopers. Noise insulation is employed for avoiding disturbance to the environment during operation. Rotek garbage chutes are specially designed for use in hotels, hospitals, residences, commercial buildings, factories, etc. If it is not possible to place the chute inside the building due to structural reasons or to replace old, unhealthy, or unfunctional chutes, the system is installed outside the building. The diameters of the Rotek garbage chutes are determined in accordance with the height of the building, field of use, and the type of garbage among diameters of Ø 450, Ø 500, Ø 550, Ø 600, or Ø 800 mm. The intake doors will be AISI 304 quality stainless steel. All chute sections will be welded by a robot under shielding gas (TIG). The welds were made with manual TIG will be rectified so the garbage can easily fall free without fastening upon any offsets or obstructions within the chute. All intake doors have 1 1/2 hour fire resistance(EI90 Fire Resistance Test Certificate- EN 1634-1:2014). All chute sections will be assembled through “male-female” joints, on suitably calibrated and self–centering. Modules that will be manufactured with cone-shaped shall not be used in the chute system.